Back in stock!
Doggie Dooley Model 3000 helps you deal effectively with your dog’s waste in a clean, ethical and environmentally responsible way. This model is a bucket-style septic tank type system suitable for two large or up to four small dogs. It is the most efficient of the Doggie Dooley models. Simply scoop your dog’s waste into the lidded bucket in the ground and add water and terminator (see below for details). The waste breaks down within the Doggie Dooley unit and the harmless odour-free liquid drains gradually away into the ground through the built-in overflow tubes. In-ground installation means there is no apparatus visible apart from the discreet foot-operated lid. This Doggie Dooley comes fully assembled but in-ground installation is required (see below).
Q. How much water and terminator do I need to add?
This Doggie Dooley unit requires approximately 1 litre of water daily (enough to bring the water level above the overflow tube to allow the liquid to drain out) and one tablespoon of digester powder or one terminator tablet per dog weekly.
The digester powder/terminator tablet is non-toxic, harmless mixture of natural bacteria and enzyme cultures designed especially for pet waste. If the unit starts to dry out it can easily be started up again with water & digester powder/ terminator.
The unit comes with a starter pack of terminator tablets or powder. View or order additional terminator tablets here and digester powder here.
Q. Which system and model do I need?
Model 3000 is a septic tank system (bucket style) suitable for 2-4 dogs respectively. It is a closed bottomed unit with a built in overflow hole. This unit comes fully assembled and requires a deeper hole for installation (see below).
Model 3800X – this is a leach bed system (open bottomed) for 2-4 dogs. The unit itself requires a hole 40cm (16 inches deep) and a further hole beneath (up to 121 cm/48 inches for maximum efficiency). With this deeper hole the unit has a bigger capacity if required.
Q. How do I install the unit in the ground?
All Doggie Dooleys require in-ground installation.
Model 3000 - This model requires digging a round hole the same diameter as the unit (approx. 35cm / 13”) and deeper than the unit itself (manufacturer’s advice is for the hole to be 120cm / 48" deep). Simply fit the unit into the hole. This will be easier if the hole narrows lower down.
Model 3800X The unit itself requires a hole 40cm/16 inches deep and a further hole beneath (up to 121 cm/48 inches for maximum efficiency). With this deeper hole the unit has a bigger capacity if required.
No posts found